Acoustic Signal; Charging The Battery - Stihl AR 900 Gebrauchsanleitung

2
Attach pouch to waist belt.
N
Insert the adapter (2).
N
Close the Velcro fastener (3) – the
N
adapter is held in the pouch.
WARNING
Never transport metallic, pointed or
sharp objects in the pouch.
AR 900

Acoustic Signal

The battery emits acoustic signals as
well as optical signals – see "Light
Emitting Diodes (LEDs) on Battery".
A
B
3
C
A A short beep
This signal is activated by releasing
the button on the battery – see "Main
Parts".
Meaning: Acoustic signal works as it
should.
B Four long beeps
One LED on battery flashes green.
Meaning: Battery's state of charge is
low – recharge the battery.
C Rapid succession of beeps
Four LEDs on battery flash red.
Meaning: Fault in battery – see
"Troubleshooting".
1)
Signal stops automatically after a
few seconds.

Charging the Battery

A factory-new battery is not fully
charged.
Recommendation: Fully charge the
battery before using your power tool for
the first time.
Connect the charger to the power
N
supply – mains voltage and
operating voltage of the charger
must be the same – see
"Connecting Charger to Power
.......
Supply".
Operate the charger indoors only in dry
locations at an ambient temperature
between +5°C and +40°C.
Push the adapter (1) into the
1)
N
charger (2) until you feel noticeable
resistance – then push it as far as
stop.
English
2
31