Light Emitting Diodes (Led) On Battery - Stihl AR 900 Gebrauchsanleitung

English
3
The light emitting diode (3) on the
charger comes on when the adapter is
inserted – see "Light Emitting Diode
(LED) on Charger"
Charging begins as soon as the light
emitting diodes (4) on the battery light
up green – see "Light Emitting Diodes
(LEDs) on Battery".
The charge time is dependent on a
number of factors, including battery
condition, ambient temperature, etc.,
and may therefore vary from the charge
time in the "Specifications".
The battery becomes hot during
operation. If a hot battery is inserted in
the charger, it may be necessary to cool
it down before charging. The charging
process begins only after the battery has
cooled down. The time required for
cooling may prolong the charge time.
AL 300 charger
The charger is equipped with a fan
which is audible when it is running.
32
End of Charge
The charger switches itself off
automatically when the battery is fully
charged:
Light emitting diodes on the battery
–
go off
4
The light emitting diode on the
–
charger goes off
The charger's fan is switched off.
–
Remove the adapter from the charger.
Light Emitting Diodes (LED)
on Battery
The light emitting diodes show the
battery's state of charge and any
problems with the battery or the power
tool being used.
Press button (1) to activate the light
N
emitting diodes – the display goes
off automatically after 5 seconds.
The acoustic signal must sound
–
briefly when the button is released
(to confirm function) – see also
"Acoustic Signal".
The light emitting diodes can glow or
flash green or red.
Light emitting diode glows con -
tinuously green.
Light emitting diode flashes
green.
Light emitting diode glows con -
tinuously red.
Light emitting diode flashes red.
1
AR 900