End Of The Programme; Stand-By Option - AEG LB1360 Benutzerinformation

There is also an alternative way of
cancelling:
1. Rotate the selector knob to the "Reset"
position .
2. Wait for 1 second. The display shows
.
Now, you can set a new washing
programme.
11.11 Opening the lid -
Adding garments
If the temperature and level
of the water in the drum are
too high and/or the drum is
still rotating you should not
open the lid.
While a programme or the delay start
operates, the appliance lid is locked. The
display shows the indicator
1. Touch the Start/Pause
The indicator
2. Wait until the lid lock indicator
stops flashing and goes off. Open the
appliance lid and drum doors. If
necessary, add or remove the items.
Close the drum door and lid. Touch
the Start/Pause
programme or the delay start
continues.

11.12 End of the programme

When the programme has finished, the
appliance stops automatically. The
acoustic signals operate (if they are
active). The display shows
The indicator of the Start/Pause
button goes off.
The lid unlocks and the indicator
goes off.
1. Press button On/Off to deactivate the
appliance.
After five minutes from the end of the
programme, the energy saving function
automatically deactivates the appliance.
.
button.
starts flashing.
button. The
When you activate the
appliance again, the display
shows the end of the
previous programme. Turn
the programme dial to set a
new cycle.
2. Remove the laundry from the
appliance.
3. Make sure that the drum is empty.
4. Keep the lid and the detergent
dispenser slightly ajar to prevent
mildew and odours.
5. Close the water tap.
11.13 Draining water out after
end of cycle
If you have chosen a programme or an
option that does not empty out the water
of the last rinse, the programme is
completed, but:
• The time area shows
display shows the lid locked
• The drum still turns at regular
intervals to prevent creases in the
laundry.
• The lid stays locked.
• You must drain the water to open the
lid:
1. If necessary, touch the Spin
to decrease the spin speed proposed
by the appliance.
2. Press the Start/Pause
• If you have set Rinse Hold
appliance drains the water and
spins.
• If you have set Night
appliance only drains the water
The option indicator Rinse Hold
Night disappears.
3. When the programme is completed
and the lid locked indicator
off, you can open the lid.
4. Press the On/Off
seconds to deactivate the appliance.

11.14 Stand-by option

The Stand-by function automatically
deactivates the appliance to reduce the
energy consumption when:
ENGLISH 23
and the
.
button
button:
the
the
and
goes
button for a few