Adjust; Validate - Wohler CFM 600 Bedienungsanleitung

Measuring
6.1

Adjust

Fig. 36: Start/Stop button for the meas-
urement
6.2

Validate

42
Use the "adjust"-measurement to adjust the
•
volume flow at the valve. The measurement
will continue until the correct volume flow is
achieved.
Press the red the start/stop button to stop the
•
measurement.
After the measurement has started the volume
flow is displayed in green. After the measurement
has been stopped the volume flow is displayed in
red, until the user starts starting a new measure-
ment or opens the menu.
NOTE!
The "Adjust" – measurement only serves to adjust
the volume flow. For this reason, the values can
not be saved.
• Use the "Validate" measurement to control the
adjustments. The device stops automatically
after each measurement. The last measured
value is displayed in green. It remains visible
in the display for approx. 5 minutes or until the
user starts a new measurement or saves the
readings.
After the measurement has been started, the de-
vice compensates the pressure.
In the display appears " Compensating pressure".
After the compensation, the measurement starts
and in the display "Measure" appears.