Honeywell TouchCenter Bus-2 012577 Montage, Anschluss, Anleitung Seite 15

Mounting and Connection Instructions TouchCenter Keypad BUS-2
9. Final mounting
After the electrical connection, fit the operating and display module with the fixing holes to the
mounting frame and push it down
1
Take care to activate the tamper switch and not to damage the cables while mounting.
1
2
wall
10. Apendix - Integration of a wallpaper
There is the possibility to use a own logo as wallpaper (e.g. company logo). The import can take
place via the integrated card reader.The card reader is located under the flap of the upper side of
the housing. Importing a wallpaper requires:
- MMC or SD memory card.
- PC/Laptop with card reader
- Working knowledge about pixel graphics.
1. Create a bmp file of the logo with an (ideal) size of 160 x 80 pixels and a colour depth of 265
colours (8 bit).The maximum size of the logo may be 320 x 240 pixels, but in that case parts of
the logo might be covered by the operating buttons! Alternatively, a graphic of the size 320 x
240 pixels can be created, on which the logo can be located at will.
2. The colour of the pixel of the left upper corner of the bitmap (logo) will be displayed as
transparent, which means this colour will not be displayed.
3. Copy the created graphic as bmp file to the root directory of MMC or SD memory card, the
extension of the file name must be .bmp. Be sure a file name exists only once.
4. Disconnect the device from the power supply! Insert the memory card into the card reader of
the operating unit.
5. Connect the power supply during active tamper contact (operating panel not replaced into the
mounting plate). The bootloader starts.
6. The bootloader copies the .bmp file into the system flash (duration ca. 1 minute, please
observe the messages on the display). Disconnect the operating unit from the power supply
and remove the memory card.
7. After commissioning the new logo will be displayed.
.
2
15