Honeywell TouchCenter Bus-2 012577 Montage, Anschluss, Anleitung Seite 12

12
6. Overview
6.1 Front view
6.2 Rear view
Connection
BUS-2
Fixing holes for
mounting plate
6.3 Mounting plate
For installation according to VdS, the mounting plate with screwable locking mechanism of
the VdS-Kit (Item no. 012578) must be used. Please note the mounting hints of the
documentation of the VdS-Kit.
Fixing holes
Fixing hole for
tear-off protection.
After mounting please
cutt off the plastic web
with wire cutter!
Strain relief
Shield connection for
tracer wire at the
mounting plate
Mounting and Connection Instructions TouchCenter Keypad BUS-2
Screw for locking mechanism
LED red
Lights up: Intrusion alarm
Flashes: Tamper- or hold-up alarm
LED green
Lights up: Unit is ready
LED yellow
Lights up: General system fault of the
central control panel
Flashes: Mains fault of the central
control panel
Fixing holes for
mounting plate
Tamper and tear off
protection switch
Cable entry by
surface mount
Buzzer
Fixing holes
Installation options for
the mounting plate, when
surface mounted over
a mounting box
(example).