Planning Information - Honeywell TouchCenter Bus-2 012577 Montage, Anschluss, Anleitung

Mounting and Connection Instructions TouchCenter Keypad BUS-2
4. General
The operating and display panel TouchCenter supplements the intruder alarm control panels
561- MB100 / HB48 / MB48 / MB24 / HB24 and also MB256 plus. The connection to the operating
and display panel required a BUS-2 connection. The TouchCenter panel also enables information
on the system state to be displayed decentrally in a clear and comprehensive manner.
Information on status and operation is displayed clearly. You can operate the system in a dialog-
managed manner.
Project-related programming of the intruder alarm control panel as well as the operating and display
panel TouchCenter is carried out per PC/laptop using the software package "WINFEM Advanced".
4.1 Required software versions:
WINFEM Advanced
Version 1.xx
Version 6.xx
4.2 Commissioning note
During commissioning, the BUS-2 address is to be set up after connecting the operating voltage for
the first time.
The BUS-2 address will be stored permanently even when disconnecting the operating voltage.

5. Planning information

5.1 Angle of view
Take the angle of the display into consideration
when determining the mounting height.
Recommended installation angle/angle of view:
5.2 VdS-Kit
For installations according to
VdS regulations a VdS-Kit is available.
Item no. 012578 VdS-Kit for TouchCenter
Mounting plate and sealing stickers for
installations and sealings according to VdS.
Type of control panel
MB100.10 / HB48.10 / MB48 / MB24 / HB24 all from V05.xx
MB256 plus from V03.xx
11
40°