Pty Program Type; Pwr Power; Af Alternative Frequencies; Regional Mode - Medion md 41133 Bedienungsanleitung

8. PTY (PROGRAM TYPE) BUTTON
Press it shortly and repeatedly to select one of the following mode:
PTY MUSIC group- - PTY SPEECH group- - PTY OFF
While selecting PTY TYPE, its selection is implemented by preset buttons as
described in preset key.(press one of the 6 preset buttons shortly and repeatedly to
select the PTY TYPE in the preset button)
When PTY MUSIC or PTY SPEECH is on, the previous PTY program and PTY word
is displayed on LCD. If there are no keys entered for 2 seconds, previously selected
PTY is searched. During 1 loop, if desired PTY is not found, NO PTY is flashed, then
return to previous normal radio and PTY word disappear.
9. POWER BUTTON
Press any button except the EJECT and OPEN button to turn on the unit, press
PWR button hold for more than 0.5 seconds to turn off the unit. (After switching on
the ACC POWER first time for 3 seconds, can only turn on the unit)
10. AF [ALTERNATIVE FREQUENCIES] BUTTON
When pressed short, AF switching mode is selected and the state of AF switching
mode is displayed by AF segment in display.
Segment off: AF switching mode off.
Segment on: AF switching mode on, and has RDS information.
Segment flashing: AF switching mode on, but RDS information is not received yet.
When AF switching mode is selected, the radio checks the signal strength of AF all
the time. The interval of checking time of each AFs depends on the signal strength
of current station, from a few minute for strong station to a few seconds for weak
station. Every time that new AF is stronger than current station, it switches over to
that frequency for very short time, and NEW FREQUENCY is displayed for 1-2
second. Because the mute time of AF switching Or checking time is very short,
it is almost inaudible in case of normal program.
During FM mode, when AF is on, SEEK, (SCAN), AUTO-MEMORY function can only
receive and save RDS program.
When pressed long, AF mode is converted to REGION ON/OFF mode.
REGIONAL MODE ON:
AF switching or PI SEEK is implemented to the station which have all PI codes are
same as current station.(PI CODE is checked when AF CHECK in progress)
REGIONAL MODE OFF:
The regional code in the format of PI code is ignored when AF switching or PI SEEK
is implemented.(PI CODE and COVERAGE AREA is not checked when AF CHECK
in progress)
Location and function of controls
17