ABB ACQ580-34 Schnellinstallationsanleitung Seite 12

12 EN – Quick installation guide
Step Tasks
19 Push the drive module carefully into the enclosure along the extraction/installation ramp. Work
preferably with help from another person as shown above. Keep a constant pressure with one foot
on the base of the module to prevent the module from falling on its back.
20 Unfasten the extraction/installation ramp and attach the drive module to the bottom plate.
LCL filter module and drive module attachments and intermediate electrical connections
21 Attach the LCL filter module and drive module to the punched section
22 Attach the LCL filter module to the side of drive module from top. Reinstall the cover.
23 Attach the drive module and LCL filter module to the bottom plate
24 Connect the LCL filter busbars to the drive module busbars with the connecting busbars.
25 Attach the LCL filter module to the drive module side from bottom.
26 Connect the LCL filter fan power supply cable to connector FAN3:LCL.
EN
Air baffles
After the electrical installation has been done, install the air baffles. For instructions, see
the air baffles and removing the cardboard covers
DA
Connect the motor cables and install the shrouds (option
DE
+B051)
See Step-by-step drawings for an installation example of standard drive configuration in
ES
Rittal VX25 800 mm wide enclosure
Step Tasks (motor cables)
FI
1 Install the grounding terminal to the drive module base.
2 Run the motor cables to the enclosure. Ground the cable shields 360 degrees at the enclosure
entry.
FR
3 Connect the twisted shields of the motor cables to the grounding terminal.
Screw in and tighten the insulators to the drive module by hand. Install the T3/W2 connection ter-
4
IT
minal to the insulators.
NL
PL
5 Connect the phase T3/W2 conductors to the T3/W2 terminal.
6 Install the T2/V2 connection terminal to the insulators. See the warning in step 4.
PT
7 Connect the phase T2/V2 conductors to the T2/V2 connection terminal.
8 Install the T1/U2 connection terminal to the insulators. See the warning in step 4.
RU
9 Connect the phase T1/U2 conductors to the T1/U2 terminal.
10 Remove the plastic sheeting from the motor cable clear plastic shroud from both sides.
11 Install the shroud (option +B051) on the motor cable connections,
SV
12 Install the lower front cover to the drive module.
13 Drill holes for the power cables to the bottom clear plastic shrouds.
TR
14 Remove the plastic sheeting from the bottom clear plastic shrouds.
15 Install the bottom first shroud on the motor cable entry.
ZH
16 Install the second shroud on the motor cable entry.
(page 105).
Do not use longer screws or bigger tightening torque than given in the
installation drawing. They can damage the insulator and cause dangerous
voltage to be present at the module frame.
(page 117).
Installing