ABB ACQ580-34 Schnellinstallationsanleitung Seite 11

Install the drive module and LCL filter module into an
enclosure
See Step-by-step drawings for an installation example of standard drive configuration in
Rittal VX25 800 mm wide enclosure
Step Tasks
Mechanical accessories
1 Attach the plinth to the floor.
2 Attach the enclosure frame to the plinth.
3 Make the bottom plate with 360-degree grounding entries for power cables. Attach the bottom plate
to the enclosure frame.
4 Attach the punched section to the back of enclosure frame.
5 Attach the mounting brackets to the punched section.
LCL filter module
6 Install the pedestal to the LCL filter module.
7 Install the cooling fan to the LCL filter module.
8 Attach the LCL filter module pedestal guide plate to the enclosure bottom plate.
9 Attach the drive module pedestal guide plate to the enclosure bottom plate.
10 Attach the extraction/installation ramp to the LCL filter module pedestal guide plate.
11 To prevent the LCL filter module from falling, attach its lifting lugs with chains to the enclosure frame.
12 Push the LCL filter module carefully into the enclosure along the extraction/installation ramp. Work
preferably with help from another person as shown below. Keep a constant pressure with one foot
on the base of the module to prevent the module from falling on its back.
13 Unfasten the extraction/installation ramp and attach the LCL filter module to bottom plate.
Drive module
14 Attach the extraction/installation ramp to the drive module pedestal guide plate.
15 Remove the sheeting from the clear plastic shrouds of the drive module from both sides.
16 Install the top metallic shroud to the drive module.
17 Install the back shrouds to the drive module.
18 To prevent the drive module from falling, attach its lifting lugs with chains to the enclosure frame.
(page 105).
EN – Quick installation guide 11
EN
DA
DE
ES
FI
FR
IT
PL
PT
RU
SV
TR
ZH