Speed Preselection - Flex RE 16-5 115 Originalbetriebsanleitung

RE 16-5 115
Checking the position of the protective
hood
The brush ring should protrude approx.
0–1 mm over the sanding plate.
The protective hood can be adjusted in height
to compensate for wear of the diamond
sanding plate.
 Loosen the locking screw in anti-clockwise
direction (1.).
 Adjust the protective hood by turning to the
desired height (2.).
 Tighten the locking screw.
Operation with guide cowl
WARNING!
Before performing any work on the power
tool, pull out the mains plug.
Attaching the guide cowl
 Loosen and remove the locking screw (1.).
 Push the guide cowl over the pins on the
housing (2.).
 Install the locking screw (3.).
 Remove the guide cowl in the reverse
order.
Attaching the planing head
 Press and hold the spindle lock (1.).
 Screw milling head onto the spindle.
 Tighten milling head clockwise using the
wrench (2.).
 Remove milling head in reverse sequence.
Adjusting the planing depth
The planing depth can be adjusted in 6 stages
from 0 to 6 mm.
 Loosen the locking screw in anti-clockwise
direction (1.).
 Adjust the protective hood by turning to the
desired height (2.).
 Tighten the locking screw (3.).

Speed preselection

To set the operating speed, move the dial to
the required value.
23