Flex RE 16-5 115 Originalbetriebsanleitung Seite 24

Switching the power tool on/off
Short-term operation without detent
 Push the rocker switch forwards and hold.
 Release the rocker switch to switch off.
Non-stop operation with detent
NOTE
If there is a power failure, the switched on
power tool will not start running again.
 Push the rocker switch forwards and
engage by pressing the front part.
Switching off the equipment:
 To switch off, release the rocker switch by
pressing the rear part.
24
NOTE
The tool will switch off automatically in the
event of a short overload. To restart the tool,
switch off and back on again.
If overheating occurs due to overload during
non-stop operation, the speed of the power
tool will be reduced automatically until the
power tool has cooled down sufficiently. At the
end of the cooling mode, the tool switches off
automatically.
To restart the tool, switch off and back on
again.
Using a dust extractor
CAUTION!
The concrete planer must be connected to a
dust extractor during operation. The
extraction system must be approved for
stone dust.
For the extraction of particularly harmful,
carcinogenic, dry dust, a special extractor
approved for such use must be used.
In the event of a fault in the extractor, stop
work immediately and switch off the power
tool. Rectify the fault before bringing it back
into operation.
NOTE
Connect a class M dust extractor when using
the concrete planer RE 16-5 115.
 Attach the suction hose to the connection.
 Connect the suction hose to the dust
extractor. Observe the operating
instructions of the dust extractor. Check the
attachment. Use a suitable adapter if
necessary.
RE 16-5 115