Care And Maintenance - KIKKA BOO 4FIX Gebrauchsanweisung

3.CAR SEAT COMPONENTS
3.1 Headrest; 3.2 Red Belt Guide Hook; 3.3 Fabric Cover; 3.4 Shoulder Pad; 3.5 Cushion; 3.6 Shoulder Harness; 3.7 Buckle; 3.8 Crotch Pad; 3.9 Adjusting Device
3.10 Harness Adjustment Strap; 3.11 Recline Handle; 3.12 Base; 3.13 ISOFIX Connector; 3.14 ISOFIX button; 3.15 Headrest Handle; 3.16 Blue Belt Guide Hook
3.17 Blue Belt Guide Hook; 3.18 Metal Connector; 3.19 Backrest;

4. CARE AND MAINTENANCE

4.1 How to use the harness buckle
4.1.1 Guide the two buckle latches together.
4.1.2 Make sure right side up.
4.1.3 Engage them before putting them into theharness buckle , this should make a CLICK noise (Figure 4).
4.1.4 Pull shoulder belts to remove all slack from the lap section ensuring the harness lies at and harness buckle locked. Open the harness buckle by pressing the red
button (Figure 5).
4.2 Care for the harness buckle
It is vital for the safety of your child that the harness buckle works correctly. Malfunctions of the harness buckle are usually caused by accumulations of dirt
or foreign bodies. Malfunctions are as follows:
· The buckle latches are ejected only slowly when the red release button is pressed.
· The buckle latches will no longer lock home (i.e.they are ejected again if you try to push them in).
· The buckle latches engage without an audible CLICK
· The buckle latches are di cult to insert (you feel resistance).
· The buckle only opens if extreme force is applied.
4.3 Remedy
Wash out the harness buckle so that it functions properly once again.
4.4 Removing 5-point harness
4.4.1 Loosen the 5-point harness of the child seat as much as possible by press the button of the crotch belt.
4.4.2 Turn the baby safety car seat to back, unzip the seat cover.
4.4.2 Turn the baby safety car seat to back, unzip the seat cover.
4.4.3 Loosening the shoulder belt in order to access the metal link and connector at the back of the child seat, remove the belt from connector,then remove the
shoulder belt from metal link (Figure 6).
4.4.4 Then from the front of the child seat, pull out shoulder belt through the slots (Figure 8).
4.4.5 Pull below both,the shoulder pads and the belts to the front through the slots. (front side of the child seat).
4.4.6 Remove the shoulder pads from the shoulder belts and put them in the storage bag.
4.4.7 Roll the shoulder belts separately on both side and place them into the fabric cover from the slot of fabric.
4.4.8 Grasp the metal plate from underneath and turn it into a vertical position. Push upwards and slide the metal plate through the slot (Figure 9).
4.4.9 Remove the harness buckle with the crotch pad and store it in the storage bag (Figure 10).
4.5 Cleaning the harness buckle
4.5.1 Open the harness buckle (press the red button).
4.5.2 Grasp the metal plate from underneath and turn it into a vertical position.
4.5.3 Slide the metal plate through the slot.
4.5.4 Remove the harness buckle.
4.5.5 Soak the harness buckle in warm water with washing-up liquid for at least an hour.Then rinse and dry it thoroughly.
4.6 Adjust the angle of child safety car seat. There are 4 levels adjustment in the child safety car seat.Before xing a child in the child restraint system,the seat
must be set on the recline position for rear-facing use (see Figure 15) or in the sitting position for forward-facing use (Figures 12, 13, 14). To achieve that,use
the recline handle located in front of the child restraint system between the sitting part and the base to adjust the desired position (Figure 11).
Total has four level positions:
· rst level (Figure 12) · second level (Figure 13) · third level (Figure 14) · forth level (Figure 15)
4.7 Adjust the length of harness
In order to protect your child much better,after x him/her in the child restraint system and lock the buckle,you should tighten the harness so they are snug and at
against the child' s body,they should never be twisted or loose.
4.7.1 To tighter the harness,pull the shoulder belt upwards to remove the slack from the lap sections of the harness,at the same time to pull the adjuster crotch belt
coming from the lock by your another hand (Figure 16).
4.7.2 To lengthen the harness,press the button on lock between the child' s two leg, then pull the two shoulder belt simultaneously in your direction, please note while
you are doing this hold the harness, not the harness cover (Figure 17).
CAUTION! Check that the harness straps are not twisted and that they have been correctly inserted in the belt slots on the cover.
4.8 Adjusting the headrest in an installation with a 5 point harness.Group 0 and 1.
ENGLISH