Werbung
18. Screw nut (Part 24)on the machine screw M3 x 35mm ( Part18) so that ca 20mm thread is free and then add the
wooden bal l ( Part 27) then insert it further through the reflector (Part 19) adding an angle hole piece (Part 12)
(long hole ) and finish with a washer and nut (Photographs 18a -18e )
18a
19. Mount the paraobol reflector on the same machine screw M4 x70mmon the camera and fix with two lock nuts
(Part 8).
Fertig!
Function:
Place the moon buggy on the floor and pull backward to wind up the friction motor then let it go.
Note
:
Do not over wind the spring action!
Lubricate the motor a few drops of oil to the gears!
6
Instructions
18b
18c
19a
18d
19b
18e
E106887#1
Werbung
