Werbung
6. Axle fixing
Measure and mark a line 1mm past the first hole , left and right (in a 7 hole length of metal strip ) ( Use a felt tip pen )
Use a pair of pliers to bend the ends up at 90 degrees ( Photographs 6b-6c)
Note:
You can also bend the ends in a vice!
An der gegenüberliegenden Seite den Flachstab ebenso einspannen und abwinkeln (U-Form/6e-6f ).
Note:
Ensure both ends are bent in the same direction!
6a
7. Fitting the axle to the chassis
See photo 7a – Screw a lock nut ( Part 23 ) on the M4 x 10 ( Part 16 ) and then remove it
Now add a washer (26) and then insert the machine screw through from underneath through the second hole
from the front in the plywood chassis ( Photograph 7b)
Place the axle holder on top so that it is central and then add the lock nut ( Plastic ring faces down ) so the axle
holder can move without play.
Note:
Mounting the lock nut ( 7d)!
7a
8. The front axle
Measure and saw the threaded axle rod M4 x 150mm ( Part 15 ) to 115mm long.
File the sawn end to remove any burr.
9. Mounting the wheels
Assemble the wheels centres (28 ) and tyres ( 29) ( 9a +9B )
Slide a wheel on each axle of the friction motor
9a
10. Screw a M4 domed ( Part 10) nut on the threaded axle ( Photograph 10a )
Slide the threaded rod in the metal axle holder then screw on the next pair of lock nuts (8) ( After the end of the
axle ) the finally finish with a domed nut.
10a
E106887#2
Instructions
6c
6b
7b
8b
8a
10b
6d
7c
8c
9b
10c
6f
6e
7d
9c
3
Werbung
