Werbung
11. Slide the threaded rod in the metal axle holder then screw on the next pair of lock nuts (8)
(After the end of the axle ) the finally finish with a domed nut.
Slide the angle bracket ( Part 12 ) on the axle rod then a nut ( Part 8) ( photograph 11b )
Turn the threaded rod until the angle bracket lies against the lock nuts ( Photograph 11b )
Add two nuts ( Part 8) on the outside of the threaded rod so the it can turn ( photograph 11c-11d )
Finally add the second wheel and fix it with a domed nut ( Photograph 11e)
11b
11a
12. Steering wheel ( Part 9)
Drill it out to 4mm
13. Steering
Slide a washer (26) on to the machine screw M4 x 50mm (7) ( Photograph 13a)
Insert the machine screw up through the central hole in the chassis (13a) add another
Washer the two nuts (Part 8) tighten the lock nuts so that the machine screw can turn (Photographs13c-13d)
Then add another nut ( Part 8) then a 3 hole metal strip (Part 13 ) then another nut so that the metal strip is about
15mm from the chassis (Photographs 13d –13 e)
13a
Finally add another nut so the steering wheel can be slid on and fixed with a domed
nut. (Photograph 13 e).
Note:
The steering mechanism should turn!
14. Insert a M4 x 16mm machine screw (Part 16) through the long slot in the angle piece on the front axle (Photo-
graphs14a -14b)
Add a 7 hole metal strip ( Part 11) then a lock nut ( Part 23) so that it can turn without play on the machine screw
(Photograph 14 c )
14a
4
Instructions
11c
13b
11d
13c
14b
11e
13d
13f
14c
E106887#1
13e
Werbung
