Werbung
15. Insert a M4 x 10mm( Part 16) up through the last hole in the steering linkage ( Part 13 on steering wheel ) Then
connect the free end of the 7 hole link ( Part 11 ) insert a machine screw from underneath and fix the two with a
lock nut (23) so that the completed steering mechanisn. Can move without play ( photographs 15c +15d )
:
Note
Adjust the linkage mechanism so that it can turn left and right!
15a
16. Make a mall hole in the flat end grain side of the pine piece (D) 5mm in from the end ( Photograph 16a)
Also make a hole 10mm from the end in the long side of the pine piece ( Photographs 16 +16C)
On the long grain side fix a 7 hole metal strip with a screw and washer ( Photographs 16b -16e )
16a
Place a washer ( Part 25 ) on a screw 2 x 16mm ( Part 20 ) ( Photograph 16 f )
Insert the screw through the distance tube ( Part 22) and the mount it on the pine block ( 16h)
16f
17. Add a washer ( part 26) on the machine screw M4 x 70mm And insert it up through the front hole in the chassis (Part
17a) add a washer (26 ) on top and then a nut ( Part 8) and then tighten ( Photograph 17a )
Add another nut ( Part 8) and screw it down until its about 20mm from the top of the chassis.
Then mount the camera on the thread and finish with two lock nuts ( Part 8) ( See photographs 17b -17d )
17a
E106887#2
Instructions
15b
16b
16g
17b
15c
16c
16d
17c
15d
16e
16h
17d
5
Werbung
