IKEA RYTMISK Benutzerhandbuch Seite 11

ENGLISH
What to do if...
If there is a fault, first try to find a solution
to the problem yourself. If you cannot find a
solution to the problem yourself, contact an
authorized service center.
PROBLEM
Appliance not stable
Appliance is not in horizontal
position
Performance in terms of oil cap-
ture are not satisfying
Appliance does not work
The light does not work
Noise of hood is higher than
customer expectation.
Before contacting the Authorized Service Centre:
Switch the appliance on again to see if the problem has disappeared. If not, switch it off
again and repeat the operation after an hour.
If your appliance still does not work properly after carrying out the checks listed in the trou-
bleshooting guide and switching the appliance on again, contact the Authorized Service
Centre, clearly explaining the problem and specifying:
• the type of fault;
• the model;
• the type and serial number of the appliance (given on the rating plate).
POSSIBLE CAUSE
The appliance is not correctly installed Follow the Installation instruction
The appliance is not correctly installed Follow the Installation instruction
Oil and grease on metal filters or
charcoal filters.
The appliance is not correctly con-
nected
The LED is broken
Air outlet diameter in the wall is too
small, causing a pressure drop and
an increase in motor speed.
Product is installed in recirculation
mode.
More than one bend in the ventila-
tion duct.
If you operated the appliance wrongly,
or the installation was not carried out
according to the Assembly instructions, the
visit from the Authorized Service Centre
technician may not take place free of
charge, even during the warranty period.
SOLUTION
enclosed to the appliance.
enclosed to the appliance.
Follow the cleaning frequency of filters
as described in the user manual
Verify that the main cable is connected
to the motor group or the plug is con-
nected to the socket
You can replace the lamp without con-
tact the Authorized Service Centre.
Follow the Installation instruction
enclosed to the appliance.
Product in recirculation mode(and
using a charcoal filter) will generate an
higher noise than a product in extra-
tion mode.
If the exhaust system in the build-
ing has multiple bend in or a long
distance, this can increase the noise of
the product.
11