Velleman PEREL WC224 Bedienungsanleitung Seite 5

WC224
Do the same with the anemometer.
Powering the Outdoor Sensor
The outdoor sensor requires two AA/R6 batteries. Open the battery compartment of the
weather station. Insert the battery observing the correct polarity and re-insert the
battery door.
We recommend using lithium or alkaline batteries. Rechargeable batteries are not
recommended as they have lower voltages, do not operate well at wide temperature
ranges and do not last long, resulting in poorer reception.
Synchronizing the Sensor and Weather Station
Before mounting the outdoor sensor, please refer to the chapter 5.2 Synchronizing
the Sensor and Weather Station below.
Mounting the Outdoor Sensor
The mounting assembly includes two U-bolts and a bracket that tightens around a 1 to
2" diameter pole (not included) using the four nuts.
Mount the sensor so that the wind directions (N, E, S and W) on the sensor are
matching with the real cardinal directions. Permanent wind direction errors will occur
when the sensor is not mounted correctly. Also, use the bubble level next to the rain
sensor as a guide to verify that the sensor is level.
V. 02 – 04/06/2020 5 ©Velleman nv