Troubleshooting - Hama PREMIUM AutoM120 Bedienungsanleitung

6. Troubleshooting

Error Possible cause
The main switch (10) is in
the "O" position.
The "ON/OFF" button (13)
was not pressed.
The collecting container
(7) is not inserted
The cutting rollers do not
properly.
switch on automatically
when material to be
The paper guide ap (6)
shredded is inserted.
(automatic intake) has not
been pressed down.
The connecting cable is
not connected correctly.
The socket is not live
The device is faulty.
Too much paper has been
inserted or it has been
The Overheating /
drawn in at an angle.
Overload status LED (15)
is lit up red.
The device has become
too hot.
The Container LED (14) is The collecting container
lit up red. (7) is full.
The cutting rollers
continue to run after the There is jammed paper in
shredding process has the intake shaft (1)/(2).
been completed.
7. Technical data
Remedy
Input voltage
Move the main switch
Mains frequency
(10) to the "|" position.
Max. power consumption
Press the "ON/OFF"
button (13) until the
Dimensions (W x H x D)
Ready status LED (16)
lights up solid green. Weight (net)
Weight (gross)
Insert the collecting
container (7) properly.
Basket capacity for paper and plastic cards
Hold down the paper Max. noise level
guide ap (6) and insert
Max. cutting performance - paper (70 gsm)
the paper stack as far as
it will go.
Ensure that the mains Max. cutting performance - paper (80 gsm)
plug is in the mains
socket
Max. cutting performance - plastic cards
Check the domestic fuses
Max. cutting speed
Notify Customer Services.
Follow the steps in
Max. feed width for paper / plastic cards
4.5 Forward/reverse
modes and clearthe
Cutting size for paper / plastic cards
paper jam.
Max. constant operation time
Switch the device off and
allow it to cool down for at
least 60 minutes.
Nominal rest period
Empty the container
Protection class (as per DIN 66399)
(7) as described in5.1
Emptyingthe container.
Safety levels (as per DIN 66399)
Follow the steps as
* Thicker paper, moisture or any voltage other than that permitted may reduce the
described in 4.5
performance.
Forwards / backwards
modes. Switch off the
8. Warranty disclaimer
machine and check for
All of the technical information, data and instructions regarding operation contained in
pieces of paper stuck in
these operating instructions was up to date at the time of printing and is provided based
the intake shaft.
on previous experience and to the best of our knowledge.
Hama GmbH & Co KG assumes no liability and provides no warranty for damage resulting
from improper installation/mounting, improper use of the product or from failure to observe
the operating instructions and/or safety notes.
220-240 V~
50 Hz
80 W
37.0 x 52.3 x 26 cm
7600 g
8900 g
25 litres
< 60 dB
6 sheets (DIN A4 paper)* manual
125 sheets (DIN A4 paper)* auto
5 sheets (DIN A4 paper)* manual
120 sheets (DIN A-4 paper)* auto
1
1.8 m/min. manual
2.2 m/min. auto
225 mm
4 x 20 mm
8 minutes manual
60 minutes auto
60 minutes
3
P-4 / T-4 / E-3
5