g
6. Troubleshooting
■
This device features a motor with a function that protects against pa-
per jams and overloads.
■
Do not use the shredder continuously for longer than
■
Limit continuous use of the device to a maximum of 3 minutes,
followed by a pause of at least 20 minutes with the device swit-
ched off. The motor switches off automatically when the device is
overloaded (after a minimum of 20 minutes).
■
The device switches off automatically when the maximum sheet capa-
city has been exceeded.
In either case, proceed as follows:
■
Unplug the device at the socket.
■
Wait at least 20 minutes until the overload protection has reset.
■
Remove any paper sticking out of the device by pulling it up and out
of the feed shaft (4).
■
Reconnect the device to the power supply and set the operating switch
(2) to REV.
■
Pull any remaining paper up and out of the feed shaft (4).
■
Switch the device back and forth between ON/AUTO and REV as nee-
ded.
■
To return to standby mode, set the operating switch (2) to the ON/
AUTO position.
7. Technical data
Input voltage
Mains frequency
Maximum power consumption
Power consumption (standby)
Dimensions (L x W x H)
Weight (net)
Weight (gross)
12
220-240 V~
50 Hz
141 W
0.5 W
30,0 x 17,5 x 28,0 cm
1,664 kg
1,943 kg
Home S7