Connecting Power; Connecting The Interface - OHAUS Ranger 7000 Serie Handbuch

EN-2

2.2 Connecting Power

AC Power Cord Installation
Connect the AC mains power cord to the instrument's power input connector, and then connect the AC plug to a suitable
electrical outlet.
Attention: For optimal weighing performance, allow the
scale to warm up for 60 minutes prior to use.

2.3 Connecting the Interface

Use the built-in RS-232 port to connect either to a computer or a printer with a standard (straight-through) serial cable. Or
connect using the scale's USB port.
Connect to base
Used for
options
2.4 Levelling the Instrument
To level the instrument, adjust the feet/leveling wheel so the bubble is centered in the circle of the level indicator. Be sure the
equipment is level each time its location is changed.
Interface connections on back of Terminal.
Thread terminal cable along cable coils on bottom of scale.
Or pass cable through groove near release button.
®
RANGER 7000 SCALES
RS232
USB
USB slave
Used for
options
Cable groove
host