Before First Use - Klarstein LUMINANCE FROST Handbuch

BEFORE FIRST USE

• Before use, remove all packing materials, including bottom cushions, foam pads
and tapes inside of the refrigerator; tear off the protective film on the doors and the
refrigerator body.
• Keep away from heat and avoid direct sunlight. Do not place the freezer in moist or
watery places to prevent rust or reduction of insulating effect.
• Do not spray or wash the refrigerator; do not put the refrigerator in moist places
easy to be splashed with water so as not to affect the electrical insulation properties
of the refrigerator.
• The refrigerator is placed in a well-ventilated indoor place; the ground shall be flat,
and sturdy (rotate left or right to adjust the wheel for levelling if unstable).
• The top space of the refrigerator shall be greater than 30 cm, and The refrigerator
should be placed against a wall with a free distance more than 10 cm to facilitate
heat dissipation.
• Before initial start, keep the refrigerator still for half an hour before connecting it to
power supply.
• Before putting any fresh or frozen foods, the refrigerator shall have run for 2-3
hours, or for above 4 hours in summer when the ambient temperature is high.
• Spare enough space for convenient opening of the doors and drawers.
Positioning of shelves and door compartments
The refrigerator is equipped with several shelves that can be positioned as required. To
enable the storage of food packaging of different sizes, the door compartments can
be mounted at different heights. To do this, pull the balcony towards the arrows until it
detaches and then position it as required.
EN
23