Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
ENGLISH
The side brushes sweep dirt from the edges of f oors and from corners, and direct it to the centre of the sweeper
where it can be picked up by the main brush.
Replacing the side brush
- Remove the three bolts 1, which f x the brush to the hub, and remove the old brush.
- Fit a new brush and adjust it.
!
Warning!
when the motor-sweeper is at rest, the side brush must always be lifted above the ground to avoid de-
formations (bending of the brush's bristles).
Adjusting the side brush
(see "controls" - f g.1 - point 14)
The sweeper drive system comprises an electric motor 1, which drives the rear wheels and a control unit 2
which controls forward/reverse direction.
By pushing the switch 7 ( f g.1) placed on the steering wheel, the operator selects the direction (FOR WARD or
REVERSE) of the machine.
By pressing on the pedal 12 (f g.1) the speed of travel is chosen.
!
For safety reasons the sweeper only functions with an operator on board. The microswitch integrated to the
seat detects the presence of an operator and activates the electrical circuits.
The sweeper is steered by means of steering wheel 1. The steering wheel requires no adjustment.
The brake is used to stop the sweeper when it is moving and to keep it stationary on slopes.
- The braking effect is provided by drums acting on the front wheel.
- The pedal control 1 is of mechanical type.
To lock the pedal in the parking position, proceed as follows:
* Push the pedal 1 fully down.
* Pull the handle 2 placed on the dashboard.
- To release the brake, press on the pedal.
- When the brake tends not to stop the sweeper, adjust the brake using the adjusting 3 placed on the front wheel.
40
SIDE BRUSH
DRIVE SYSTEM
STEERING SYSTEM
SERVICE AND PARKING BRAKE
(FIG.4)
(FIG.5)
(FIG.6)
(FIG.7)
Werbung
Inhaltsverzeichnis
