Bosch Rexroth PRC 7 00-L /W 1000 Serie Typspezifische Anleitung Seite 41

R911404358 | PRC 7x00-Lx/Wx-1000 Bosch Rexroth AG | Electric Drives and Controls
20021 Primary circuit different current
20022 Main switch tripped
20023 Transformer overtemperature
20024 Diode overtemperature
20025 Transformer overload
20026 Supply voltage fault
20027 Current measuring circuit open
20028 Error reset
20029 DC link not ready
20030 Change of HW description of control unit
20031 Checksum error HW update
20032 Checksum error FW update of the PU (power unit)
20033 Ghostrun mode active
20034 Ghostrun mode (use of default parameter) active
30000 Invalid reference curve
30001 Inconsistent reference curve
30002 No sequence block
30003 No start signal
30004 Spot data not available
30005 Weldjob not available
30006 Electrode not available
30007 Gun not available
30008 Transformer not available
30009 Transformer power class not available
30010 Global data not available
30011 Diode not available
30012 Current not within the programmed limits
30013 Phase angle values not within the programmed limits
30014 Force values not within the programmed limits
30015 Total of weld times not within the programmed limits
30016 Start inhibit on
30017 Timer not ready
30018 Program not correct
30019 Stepper curve does not exist
30020 Empty sequence block
30021 Sequence block length 0
30022 Start without external weld contactor enable
31000 Power unit excessive current
31001 No current in sequence
41/46