Install The Grass Catcher; Install The Mulch Plug; Set The Blade Height; Install The Battery Pack - GreenWorks G24X2LM41 Bedienungshandbuch

3. Tighten the knobs onto the cam locks.
4. Do the same operation on the other side.
6.4

INSTALL THE GRASS CATCHER

Figure 4
1. Remove the mulch plug.
2. Open the rear discharge door and hold it.
3. Hold the the grass catcher by its handle and put the hooks
over the slots.
4. Close the rear discharge door.
6.5

INSTALL THE MULCH PLUG

Figure 5.
1. Remove the grass catcher.
2. Open the rear discharge door and hold it.
3. Hold the mulch plug by its handle and fit it in the
discharge chute.
4. Close the rear discharge door.
6.6

SET THE BLADE HEIGHT

The machine can be set to different blade heights.
Figure 6.
1. Push the height adjustment button, move the height adjust
gear to a higher position to increase the blade height.
2. Push the height adjustment button, move the height adjust
gear to a lower position to decrease the blade height.
6.7

INSTALL THE BATTERY PACK

Figure 7
WARNING
• If the battery pack or charger is damaged, replace the
battery pack or the charger.
• Stop the machine and wait until the engine stops before
you install or remove the battery pack.
• Read, know, and do the instructions in the battery and
charger manual.
WARNING
USE ONLY 24V BATTERY. DO NOT USE DUAL-
VOLTAGE 24/48V BATTERY.
Both batteries should be installed into the compartments in
order to start the machine.
1. Open the battery door.
2. Align the lift ribs on the battery pack with the grooves in
the battery compartment.
NOTE
English
3. Push the battery pack into the battery compartment until
the battery pack locks into place.
4. When you hear a click, the battery pack is installed.
5. Do the same operation with the other battery.
6. Close the battery door.
The motor starts only when you put in the safety key.
6.8

REMOVE THE BATTERY PACK

Figure 7
1. Open the battery door.
2. Remove the safety key.
3. Push and hold the battery release button.
4. Remove the battery pack from the machine.
7

OPERATION

Wear eye protection during operation.
7.1

START THE MACHINE

Figure 8.
1. Put in the safety key.
2. Push and hold the start button.
3. While you hold the start button, pull the bail switch in the
direction of the handle bar.
4. Release the start button to start the machine.
7.2

STOP THE MACHINE

Figure 8
1. Release the bail switch to stop the machine.
Wait until the blades fully stop before you start the machine
again. Do not quickly turn the machine off and on.
Always remove the safety key and battery pack after you
complete the work.
7.3

EMPTY THE GRASS CATCHER

1. Stop the machine.
2. Remove the safety key.
3. Remove the battery pack.
4. Open the rear discharge door and hold it.
5. Hold the grass catcher by its handle and unhook it from
the slots.
9
NOTE
WARNING
WARNING
WARNING
EN