Risk Levels; Recycle; Installation; Unpack The Machine - GreenWorks G24X2LM41 Bedienungshandbuch

EN
Symbol
4

RISK LEVELS

The following signal words and meanings are intended to
explain the levels of risk associated with this product.
SYM- SIGNAL
BOL
DANGER
WARNING
CAUTION
CAUTION
5

RECYCLE

Separate collection. You must not discard
with usual household waste. If it is necessa-
ry to replace the machine, or if it is no more
use to you, do not discard it with household
waste. Make this machine available for sepa-
rate collection.
Separate collection of used machine and
packaging let you recycle materials and use
them again. Use of the recycled materials
helps prevent environmental pollution and
decreases the requirements for raw materi-
als.
At the end of their useful life, discard batter-
ies with a precaution for our environment.
The battery contains material that is danger-
ous to you and the environment. You must
remove and discard these materials separate-
ly at a equipment that accepts lithium-ion
batteries.
Explanation
Beware of electric shock hazard.
Wait for all components of machine
to have completely stopped before
touching them.
MEANING
Indicates an imminently haz-
ardous situation,which, if not
avoided, will result in death
or serious injury.
Indicates a potentially hazard-
ous situation,which, if not
avoided, could result in death
or serious injury.
Indicates a potentially hazard-
ous situation, which, if not
avoided, may result in minor
or moderate injury.
(Without Safety Alert Sym-
bol) Indicates a situation that
may result in property dam-
age.
English
6

INSTALLATION

Do not change or make accessories that are not
recommended by the manufacturer.
Do not put in the safety key or the battery pack until you
assemble all the parts.
6.1

UNPACK THE MACHINE

Make sure that you correctly assemble the machine before
use.
• If the parts are damaged, do not use the machine.
• If you do not have all the parts, do not operate the
machine.
• If the parts are damaged or missing, speak to the service
center.
1. Open the package.
2. Read the documentation in the box.
3. Remove all the unassembled parts from the box.
4. Remove the machine from the box.
5. Discard the box and package in compliance with local
regulations.
6.2 UNFOLD AND ADJUST THE
HANDLE
Figure 2
1. Pull up and back the upper handle to lift the handle into
operation position. Make sure that the handles click into
position correctly.
2. Tighten the lower handle with the quick-release levers on
the two sides.
Make sure that the two handles are in the same position.
Do not make damage to the cables when you fold or unfold
the handle.
6.3

INSTALL THE UPPER HANDLE

Figure 3
1. Align the holes in the upper handle and the lower handle.
2. Put the cam locks through the holes.
8
WARNING
WARNING
WARNING
WARNING
NOTE
WARNING