Adjusting The Color Temperature On The Device (For Bi Color Version Only); Adjusting The Light Beam Angle (Spot Function); Setting The Desired Dmx Remote Control Channel - Walimex Pro Fresnel LED Brightlight FLD-100 Daylight Gebrauchsanleitung

• Turn the multifunction push/turn control knob (12) <MODE> to set the desired brightness.
• Turn clockwise to increase and anticlockwise to decrease.
• T he selected light output is shown as a percentage value on the device display field
<DIMMER>.
• T he brightness can be adjusted in steps of 1 % from 10 to 99 %
• The value set in the display is accepted automatically after 5 seconds or by pressing
the <MODE> button.

8.3 Adjusting the color temperature on the device (for Bi Color version only)

• Press the multifunction push/turn control knob (12) <MODE>.
• W ählen Sie die Funktion für die Einstellung der Farbtemperatur aus, das Feld <COLOR> im
Gerätedisplay blinkt.
• S elect the function for setting the color temperature, the <COLOR> field on the display will
twinkle.
• Now turn the knob clockwise to increase color temperature and turn anticlockwise to decrease.
• T he selected color temperature is shown on the device display field <COLOR> in Kelvin.
• T he colour temperature can be set in steps of 100 Kelvin from 3,200 to 5,600 Kelvin.
• The value set in the display is accepted automatically after 5 seconds or by pressing
the <MODE> button.
34
Brightness
DMX adress
Color temperature

8.4 Adjusting the light beam angle (Spot Function)

The beam angle of this Fresnel LED luminaire can be adjusted from 20° to 70° on the device
by an electronically controlled motor. Depending on your needs, you can focus and defocus
your light differently depending on the application. The focusing function cannot be controlled
by DMX control.
• Turn the <FOCUS> knob (11) to focus the light cone.
• Turn the focus dimming knob clockwise to make the lighting spot and turn anticlockwise
to make it flood.
• The lighting angle is adjustable from 20°to 70°.
• The value is not shown in the display.
• W hen the maximum value is reached, the motor function is automatically terminated.
• Please note that there is a slight delay between the movement of the button and the reaction
of the focus lenses during focusing. The delay should be low and is normal.

8.5 Setting the desired DMX remote control channel

The LED lights of the Walimex pro Fresnel LED series can be controlled by a DMX 512 control
unit. You will need a separate DMX control unit to do this. This is not included and must be
purchased separately.
• T he chosen DMX channel will be shown on the display (6) in the <DMX> field.
• P ress the <MODE> multifunction button until the DMX selection is activated (DMX field in
display twinkles).
• Turn the <MODE> knob clockwise to increase DMX address.
• Turn the <MODE> knob anticlockwise to decrease DMX address.
• The channel set in the display is accepted automatically after 5 seconds or by pressing
the <MODE> button.
• You can set channels from 1 to 512.
• Set the same channel on the LED light and your DMX control unit.
• The brightness and color temperature (Bi Color version only) of the LED light is now
controlled by the DMX signal from the DMX console.
35