Unpacking And Checking The Device - Walimex Pro Fresnel LED Brightlight FLD-100 Daylight Gebrauchsanleitung

WARNING
Danger of electric shock, burn hazard
Please note, that the device is still connected with the supply voltage even if it is switched
off. Just after disconnecting the device from the power supply through pulling out the power
cable, the device is actually de-energized.
■ Switch off your device when it is not in use.
■ Switch off your device before mounting and maintenance and disconnect from power
supply.
■ Protect your device against unintended switching-on.
■ Unplug the power cord, if the flash is not in use for a long time.
WARNING
Danger of electric shock, fire through short-circuit
A short-circuit could be caused through defect cables and through humidity or moisture.
A short-circuit can warm up the conductors, so that there isolation will melt or even melt
thoroughly. This could lead to fire.
■ Please just use the original cables, which are included in delivery. They are aligned for
your device and guarantee the necessary safety for you and your device.
■ Don´t operate the device with wet hands or feet.
■ Operate the device only in dry rooms.
■ Don´t operate the device outdoors.
■ Please only follow this instruction manual for cleaning your device.
■ Make sure, that cables and conductors won´t be damaged. Damages could be caused th-
rough heat impact, chemical influence or through mechanical impacts as rubbing, bending,
tearing, rolling over or nibbling animals.
■ Prevent your device for falling-off. In case of falling-off, please let an electrician check the
device before switching on again.
■ If your device should be damaged or defect or if you notice a burning smell:
■ Disconnect the power supply by pulling out the power cord. Never operate your device
with damaged housing, damaged reflector, defect modeling lamp, defect flash tube or
damaged power cord. Don´t open the device. Never repair the device on your own. The
device should only be repaired by electricians.
■ Please follow this instruction manual for maintaining your device.
■ Please just use spare parts, which are conform to the required specifications.
■ Illuminants must only be replaced by a skilled electrician.
WARNING
Fire danger through overheating
The device can overheat, if you operate it with covered ventilation slots. The device itself or
easily inflammable materials in close distance could catch fire.
■ Don´t cover the ventilation slots of the device during operation.
■ Remove easily inflammable materials.
■ Please just use spare parts, which are conform to the required specifications.
26
WARNING
Danger of burning on hot parts
■ The illuminant may reach temperatures of up to 40 °C.
■ Don´t touch the parts during operation and cooling down.
■ Please cool down your device before starting any mounting or maintenance arrangements.
WARNING
Danger of cutting and splintering caused by bursting illuminant
Illuminants can break or splinter when banging against the floodlight. Splinters can cause eye
and skin injuries.
■ Handle illuminants with care, to avoid breakage.
■ Make sure you do not touch the illuminant by accident when mounting or replacing accesso-
ries.
WARNING
Danger of suffocation caused by small parts
Keep the device out of the reach of children and pets.

3. Unpacking and checking the device

3.1 Carefully unpack the package content.
3.2 Check whether the scope of delivery is complete.
3.3 P lease find full scope of delivery for your device on Page 41.
3.4 Check whether the scope of delivery is free of damage.
NOTICE
If the scope of delivery is incomplete or damaged, please contact info@walser.de.
In the interest of product improvements, we reserve the right to make technical and visual ch-
anges. Illustrations may differ slightly. Not subject to identification or labelling as per Directive
2010/30/EU. Not suitable for illumination purposes in households. Specially developed for photo
and video shooting requirements.
27