Installation; Location - Fagor EAFP-800 Betriebsanleitung

1

INSTALLATION

1.0 LOCATION

The cabinet must not be tilted. If necessary, some models may be tilted to
the side indicated on the packaging. If not, it cannot be tilted. You must
wait for at least 2 minutes from standing the cabinet up before starting it
up.
Remove the packaging except the support pallet. A forklift truck or pallet
truck can be used to move it to its installation site, lifting the refrigerated
cabinet making sure that it is not unbalanced.
The cabinet must not be dragged over the floor.
The area where the cabinet is positioned must be clear and clean,
preventing the refrigerator equipment's fan from absorbing materials that
are subsequently then deposited on the condenser's ribbing, reducing
system efficiency.
Remove the pallet, taking care not to knock the unit. The cabinet can now be levelled, screwing in
or unscrewing the legs. When it is levelled, the protection film can be removed from the stainless
steel using a blunt object, and not a cutter as it could scratch the steel.
The cabinet, in its final placement, it should be removed from the wall for their support 50mm,
30mm and the sides 500 mm through the roof.
A: LEG BODY
B SCREW
Turn clockwise to lower the unit
Turn anticlockwise to raise the unit
28