Zodiac Ei2 expert Montage- Und Gebrauchsanleitung Seite 27

3.2.5 "SUMMER" and "WINTER" modes and setti ng the "Timers"
"Timer" programming is used to defi ne the appliance operati ng ti mes within the operati ng ti mes of the
fi ltering system. The daily operati ng ti mes must be suffi cient to correctly treat the water. Ei² Expert proposes
default setti ngs for Timers 1 and 2. They can be customised (see "3.2.5.b Programming the ti mers according
to the modes").
A reminder of the calculati on rule: the ideal daily fi ltering ti me is obtained by dividing the required pool
water temperature (measured in °C) by 2.
Example: for water at 28 °C, ti me = 28/2 = 14 hours per day
The Ei² Expert chlorinator can store 2 seasonal operati ng modes called by default "SUM" and "WIN". The
following setti ngs can be customised for each mode:
- the appliance operati ng ti mes, i.e. the "ti mers": T1 (Timer 1) and T2 (Timer 2)
- the required chlorine producti on rate: 10%, 20%, 30%,... up to 100%.
3.2.5.a Mode selecti on: "SUMMER" or "WINTER"
•
Press 4 ti mes to set the clock. "SUM" starts to fl ash.
•
Use the and
screen.
3.2.5.b Programming the ti mers according to the modes
The ti mes of Timers 1 and 2 cannot overlap. In additi on, the ti me range of Timer 1 must precede that of Timer
2.
TE1 / TE2 = Timer in "summer" mode No. 1 / Timer in "summer" mode No. 2
• Press 4 ti mes to set the clock. "SUM" starts to fl ash.
• Select the mode to be customised "SUM" or "WIN" using the
move to the ti mer setti ngs screen.
• Use the and
• Use the and
• Use the and
• Use the and
• Repeat these steps for Timer 2.
• Press the butt on to save the ti mers and move to confi guring the chlorine producti on rate.
•
Use the and
STANDBY = Appliance operati ng status
T = "Timer" mode (always acti ve)
SUM = "Summer" operati ng mode
80 % = chlorine producti on rate
14:25 = ti me in the 24-hour format
butt ons to choose "SUM" or "WIN" mode, then press the
08:00-12:00 = Operati ng ti me range of Timer No. 1
14:00-18:00 = Operati ng ti me range of Timer No. 2
butt ons to set the minutes of the ti me when Timer 1 must end, then press
butt ons to set the hours of the ti me when Timer 1 must end, then press
butt ons to set the minutes of the ti me when Timer 1 must start, then press
butt ons to set the hours of the ti me when Timer 1 must start, then press
butt ons to choose the required chlorine producti on rate (from 10 % to 100 %).
butt on to return to the home
and butt ons, then press
EN
to save and
to save.
to save.
to save.
to save.
11