Setting The Time - Zodiac Ei2 expert Montage- Und Gebrauchsanleitung

3.2.1 Chlorine producti on acti vated
When chlorine producti on starts, the "Start..." message is displayed on screen for about 6 seconds. "CHLORINATION" is
then displayed, indicati ng that the appliance is producing chlorine.
3.2.2 "BOOST" mode: chlorine producti on increased to 100 % for 24 h
In certain cases the pool may need higher than normal chlorinati on (stormy weather, high number of bathers, etc.).
"BOOST" mode is used to increase chlorine level quickly.
• Press butt ons
starts.
• To stop "BOOST" mode, press
When "BOOST" mode is acti vated, the rated chlorine producti on setti ngs are temporarily overridden and the
Ei² Expert chlorinator will operate for a total of 24 hours at 100 % chlorine producti on. The number of days will
therefore depend on the Ei² Expert operati ng ti mes (see "3.2.5 "SUMMER" and "WINTER" modes and setti ng
the "Timers"").
3.2.3 "LOW" mode: chlorine producti on reduced to 10 % if the pool is covered
If the pool has a covering system (shelter, shutt er, cover, etc.), "LOW" mode is designed to adapt chlorine producti on to
situati ons where the pool is covered (lower needs). Its purpose is to limit chlorine producti on to 10%.
If chlorinati on is set to 0% when closing the shutt er, "LOW" mode will keep the 0% setti ng.
This mode is also called "Shutt er" mode.
Manual acti vati on (shelter, cover, etc.):
• Press butt ons and
to 10 %.
• To stop "LOW" mode, press
Automati c acti vati on (compati ble with an electric roller shutt er):
• Make sure the cover is compati ble and connected to the chlorinator (see "2.5.2 Connecti on to an electric roller shutt er").
• "LOW" mode will automati cally be acti vated when the shutt er is closed.
• "LOW" mode will stop as soon as the shutt er is completely open.
3.2.4 Setti ng the ti me
The Ei² Expert chlorinator is fi tt ed with an internal memory. When the appliance is fi rst switched on, it is
important to leave it powered on conti nuously for at least 24 hours in order to initi ally charge the accumulator
(permanent separate power supply or fi ltering on permanently). Once charged, the accumulator has several
weeks of autonomy in the event of a power failure.
The ti me is displayed in 24-hour format.
•
Switch on the appliance and wait unti l the screen start-up sequence is fi nished.
•
Press the butt on to access the user menu, the minutes will start to fl ash.
•
Use the and
•
Use the and
•
Press the butt on to return to the home screen.
10
and simultaneously: "BOOST" is displayed on the screen and 100 % chlorine producti on
.
simultaneously: "LOW" is displayed on the screen and chlorine producti on is reduced
.
butt ons to set the minutes, then press
butt ons to set the hours, then press
to save.
to save.