How To Delete The Self-Destruct Pin; How To Unlock With The Self-Destruct Pin - iStorage diskAshur2 Benutzerhandbuch

15. How to Delete the Self-Destruct PIN

To delete the Self-Destruct PIN, first enter the "Admin Mode" as described in section 5. Once the drive is in Admin Mode
(solid BLUE LED) proceed with the following steps.
1. In Admin mode, press and hold down
"SHIFT ( ) + 6" buttons
2. Press and hold down "SHIFT (
again

16. How to Unlock with the Self-Destruct PIN

When used, the self-destruct PIN will delete ALL data, Admin/User PINs and then unlock the drive. Activating this fea-
ture will cause the Self-Destruct PIN to become the new User PIN and the diskAshur
formatted before any new data can be added to the drive.
To activate the Self-Destruct mechanism, the drive needs to be in the standby state (solid
following steps.
1. In standby state, press the "UNLOCK" button
2. Enter the Self-Destruct PIN and press the
"UNLOCK" button
Important: When the Self-Destruct mechanism is activated, all data, the encryption key and the Admin/User
PINs are deleted. The Self-Destruct PIN becomes the User PIN. No Admin PIN exists
after the Self-Destruct mechanism is activated. The diskAshur
perform a complete
Admin privileges including the ability to create a User PIN.
) + 6" buttons
reset' Section 26, on page 18) first in order to create an Admin PIN with full
www.istorage-uk.com
Solid BLUE LED will change to a blinking
LED
Blinking RED LED will become solid and then
change to a solid BLUE LED indicating the
Self-Destruct PIN was successfully deleted
will need to be partitioned and
2
RED LED) and then proceed with the
RED LED switches to all LEDs, RED,
BLUE blinking on and off
RED, GREEN and BLUE blinking LEDs will
change to GREEN and BLUE
on and off for approximately 15 seconds and
finally shifts to a solid GREEN
will need to be reset (see
2
RED
GREEN &
LEDs alternating
LED
'How to
#13