Changing The Admin Pin - iStorage diskashur PRO2 Schnellstartanleitung

Changing the Admin PIN

PIN Requirement
• PINs must be a minimum length of 7 and maximum 15 digits.
• Cannot contain all sequential numbers (2345678 or 9876543).
• Cannot contain all repeating numbers (1111111).
• The SHIFT key can be used for additional combinations (e.g. SHIFT+1 is a separate
value to just 1).
To change the Admin PIN to your own unique 7-15 digit PIN, follow the steps below.
1. In Standby State (solid RED
press and hold down both the 'UNLOCK
and number '1' buttons.
2. Enter your Admin PIN (default
'11223344') and press the 'UNLOCK'
button.
3. In Admin mode (solid BLUE
and hold down 'UNLOCK + 2' buttons.
4. Enter your NEW Admin PIN and press
'UNLOCK' button.
5. Re-enter your NEW Admin PIN and
press 'UNLOCK' button.
6. To exit Admin Mode press the 'LOCK'
button.
LED),
Solid
BLUE
GREEN
a few seconds then to a solid
solid
'Admin Mode'.
LED), press Solid
solid
Blinking
a single
GREEN
Blinking
a rapidly blinking
BLUE
successfully changed.
Solid
the standby state.
RED LED will change to blinking
LEDs
and BLUE LEDs blink rapidly together for
GREEN
BLUE LED indicating the diskAshur PRO
BLUE LED will change to blinking
BLUE LEDs.
GREEN and solid BLUE LEDs will switch to
GREEN LED blink and then back to blinking
and solid BLUE LEDs.
GREEN and solid BLUE LEDs change to
BLUE LED and finally to a solid
LED indicating the Admin PIN has been
RED LED indicates the drive is locked and in
GREEN and
and finally a
is in
2
GREEN and
5