Diskashur Led States; How To Use The Diskashur; For The First Time - iStorage diskAshur2 Benutzerhandbuch

1. diskAshur
When the diskAshur is plugged in, there are three possible behaviours for the LED indicators as shown in the table below.
2
RED GREEN
Solid Off
Solid Solid
Solid Off
1. In Factory Reset State, the drive is waiting for the operation to set up an Admin PIN.
2. In Brute Force state, the drive is waiting for an operation to get more PIN entry attempts.
3. In Standby state, the drive is waiting for an operation to unlock the drive, or enter Admin mode, or reset the drive.

2. How to use the diskAshur

The diskAshur is shipped with a default Admin PIN of 11223344 and although it can be used straight out of the box with
2
the default Admin PIN, for security reasons we
following the instructions under section 6 'Changing the Admin PIN'.
Please follow the 3 simple steps in the table below to unlock the diskAshur
Instructions - first time use
1. Connect the diskAshur
2. Enter Admin PIN (default - 11223344)
3. Within 10 seconds press the "UNLOCK" button once
to unlock diskAshur
2
Note: Once the diskAshur
solid state. It can be locked down immediately by pressing the "LOCK" button once or by clicking the 'Safely
Remove Hardware/Eject' icon within your operating system. To ensure no data is corrupted, we recommend using
'Safely Remove Hardware/Eject'.
#6
LED States
2
BLUE diskAshur
Off Factory Reset
Solid Brute Force
Off Standby
2
highly recommend a new Admin PIN be created immediately
to a USB port
2
has been successfully unlocked, the
2
State
2
1
2
3

for the first time

for the first time with the default Admin PIN.
2
LED LED State
RED LED will be solid awaiting PIN entry
RED LED remains solid
GREEN
several times and then to a solid
changing to a blinking
GREEN
GREEN
www.istorage-uk.com
and BLUE LEDs will alternately blink
BLUE
GREEN and finally solid
LED
LED will remain on and in a
by
LED