Troubleshooting; Environment Concerns; Declaration Of Conformity - Klarstein 10026951 Handbuch

Fault
Light on, but motor
does not work
Light does not work,
motor does not work
Oil leakage
Shake of the body
Insuffi cient suction
The machine inclines The fi xing screw not tight enough
According to the European waste regulation 2002/96/EG this symbol on the product
or on its packaging indicates that this product may not be treated as household was-
te. Instead it should be taken to the appropriate collection point for the recycling of
electrical andelectronic equipment. by ensuring this product is disposed of correctly,
you will help prevent potential negative consequences for the environment and hu-
man health, which could otherwiese be caused by inappropriate waste handling of
this product. For more detailled information about recycling of this product, please
contact your local council or your household waste disposial service.

Declaration of Conformity

Producer: CHAL-TEC Vertriebs- + Handels GmbH, Wallstraße 16, 10179 Berlin.
This produkt is conform to the followring European Directives:
2004/108/EG (EMC)
2011/65/EG (RoHS)
2006/95/EG (LVD)
2009/125/EG (ErP)

Troubleshooting

Cause
The leaf blocked
The capacitor damaged
The motor jammed bearing damaged
The internal with of motor off or a bad
smell from the motor
Beside the above mentioned, check the following:
Light damaged
Power cord looses
One way valve and the air ventilation
entrance are not tightly sealed
Leakage from the connection of U-
shaped section and cover
The leaf damaged and causes shaking
The motor is not tightly hanged
The body is not tightly hanged
The distance between the body and the
gas top too long
Too much ventilation from open doors
or windows
The hanging screw not tight enough

Environment Concerns

Solution
Get rid of the blocking
Replace capacitor
Replace motor
Replace motor
Replace lights
Connect the wires as per the
electric diagram
Take down the one way valve
and seal with glue
Take U-shaped section down and
seal with soap or paint
Replace the leaf
Lock the motor tightly
Fixed the body tightly
Readjust the distance
Choose a new place and resem-
ble the machine
Tighten the hanging screw and
make it horizontal
Tighten the hanging screw and
make it horizontal
10