Klarstein 10026951 Handbuch Seite 7

• To ensure that you get the best Warranty experience for your cooker hood, please provide copies
of the Warranty Card and purchase receipt, when booking warranty work with the Customer Ser-
vice department.
• The air must not be discharged into a flue that is used for exhausting fumes from appliances bur-
ning gas or other fuels (not applicable to appliances that only discharge the air back into the room•
• Warning: Failure to install the screws or fixing device in accordance with these instructions may
result in electrical hazards.
• The cooker hood uses high quality materials, and is made with a streamlined design.
• Equipped with a large power low noise electric motor and centrifugal leaf, it produces strong
• suction, low noise, non stick grease filter and easy to clean.
• With the isolated low voltage circuit board control, 12vAC input, the lights are therefore safer.
• Special wind tunnel construction and oil collector design, free dirt will be absorbed in a second.
• The cooker hood should be placed at a distance of 65-75cm (26-30inch) from the cooking surface
for the best effect. See Pic 1.
• Install the hook on a suitable place once the installation height is fixed, and keep it in line. The
fixed position of the inside chimney bracket is the place of chimney.
• Fix the outside chimney bracket on the outside chimney, and be sure that the inside chimney can
be adjusted the height in it freely as well as fixing the extensible pipe. Afterwards, install the ex-
tensible pipe and chimney on the cooker hood. See Pic 3.
• Put the cooker hood on the hook. See Pic 4.
• Adjust the height of the inside chimney to the position of the inside chimney bracket and fix on it
by screw,after ajusting the position,fix the body with safety screw. See Pic 5.
Note: The two safety vents are positioned on the back casing, with diameter of 6mm.
7
Feature
Mounting