After A Fall Replacing Equipment; Preliminary And Periodical Checks; Before Each Use - Harken Industrial R27 Handbuch

PRELIMINARY AND PERIODICAL CHECKS

After a fall, replacing equipment
WARNING!
Any trolley wich has been subjected to the forces of arresting a fall must be immediately withdrawn
from use and not used again until confirmed in writing by and authorized Harken R27 Inspector that
it is acceptable for use.
PRELIMINARY AND PERIODICAL CHECKS

Before each use

Before using the R27 trolley, check its condition and visually check each component per manufacture's
instructions. The following are Harken specific inspection procedures:
A - Inspect pinstop
Inspect pinstop for spring degradation, cracks or wear
that may affect locking strength and operation.
Check drive pin holding plastic latch to post to make
sure it is secure.
B - Inspect pivot pin retaining screws
Inspect pivot pin retaining screws in trolleys and coupler.
Make sure coupler/pivot pin retaining screws have not
loosened and are tightened securely in coupler.
14
Drive Pin
CORRECT
ENGLISH
INCORRECT
24/07/20