Dell EMC PowerEdge R630 Handbuch Seite 134

2. Follow the procedure listed in the Before working inside your system section.
3. Keep the Philips #1 screwdriver handy.
NOTE: If the System has three PCIe cards, ensure that you install the PCIe cooling shroud in your System.
1. Orient the NDC so that the Ethernet connectors fit through the slot in the back panel.
2. Align the captive screws at the back-end of the card with the screw holes on the system board.
3. To ensure that the connector on the card is in contact with the connector on the system board, press the touch point on the
card.
4. Tighten the two captive screws to secure the NDC to the system board.
5. Install the expansion card riser 3.
Figure 60. Installing the NDC
1. captive screw socket (2)
3. captive screw (2)
5. NDC
Follow the procedure listed in the After working inside your system section.
Related references
Sicherheitshinweise on page 82
Related tasks
Vor der Arbeit an Komponenten im Innern des System
Installing expansion card risers
Nach der Arbeit an Komponenten im Innern des System
Removing the network daughter card
134 Installieren und Entfernen von System-Komponenten
on page 83
on page 123
on page 132
2. connector on the system board
4. touch point (2)
6. back panel slots for Ethernet connectors
on page 83