Grundig GCI-K1527V-1 Kurzanleitung Seite 8

This Quick Guide is for quick installing and connecting of the GRUNDIG camera model GCI-K1527V-1. The
complete user manual can be found on the CD in the package or can be downloaded from our website:
www.grundig-cctv.com
Camera's Connectors
No.
1 RJ-45
2 BNC
Power
3
(DC 12V / AC 24V)
4 Default Button
5 Alarm & Audio I/O
6 SD Card Slot
NOTE: It is not recommended to record with the SD card for 24/7 continuously as it may not be able to
support long term continuous data reading/writing. Please contact the manufacturer of the SD card
for information regarding the reliability and the life expectancy.
IP Dome Camera Installation
Please follow the instructions below to complete the IP Dome Camera installation.
Ethernet Cable Connection
Connect one end of the Cat. 5 Ethernet cable to the RJ45 connector of the IP Camera, and the other end of
the cable to the network switch or PC.
NOTE: When connecting the IP Camera directly to a PC, you might need to use an Ethernet crossover
cable.
NOTE: Check the status of the link indicator and activity indicator LEDs; if the LEDs are unlit, please
check the LAN connection.
Downloaded from www.Manualslib.com
Connector Pin
- For network and PoE connections
1 GND
2 BNC
1 AC 24V 1
2 AC 24V 2
3 DC 12V 1
4 DC 12V 2
Press the reboot button with a proper tool for at least 20 seconds to
-
reboot the camera.
1 Audio In L
2 Audio In R
3 GND
4 Audio Out L
5 Audio Out R
6 Alarm Out +
7 Alarm Out −
8 Alarm In +
9 Alarm In −
Insert the SD card into the card slot to store videos and snapshots.
-
Do not remove the SD card when the camera is powered on.
manuals search engine
Definition Remarks
For analogue video output
Power connection
Audio In
Audio Out
Alarm connection