Grundig GCI-K1527V-1 Kurzanleitung Seite 10

 Right-click on the information bar and press <Install ActiveX Control...> to permit ActiveX control
installation.
 In the pop-up security warning window, click <Install> to start downloading the GRUNDIG Viewer software.
 Press <Finish> after GRUNDIG Viewer installation is complete.
Change the IP Address with the GRUNDIG Finder Software
Start the GRUNDIG Finder and press the <Find Device> button. All attached GRUNDIG cameras will appear in
the list below (see Picture 1). Right-click on the camera and select <Network Setup>.
Picture 1:
Enter the default user name (admin) and password (1234) in the prompt request dialogue (see Picture 2).
A window will pop up (see Picture 2), where you can adjust the IP address of your camera depending on your
network setup (DHCP or static). The camera will reboot with a new IP address after you press <Apply>.
Browser-based Viewer
The main page of the IP Camera user interface is
shown in the picture on the right. Please note that
function buttons may vary depending on the camera
model.
Downloaded from www.Manualslib.com manuals search engine
Picture 2: