Other Cautions; Specifications - Korg M3 Bedienungsanleitung

3.
Making sure that retaining bar "A" is oriented correctly
as shown below, lay it gently over the module.
Align the screw holes of the keyboard assembly with the
screw holes of retaining bar "A," and lightly fasten the
four screws using only your fingers. Then use your Philips
(+) screwdriver to firmly tighten all four screws.
Don't tighten the screws by force if they are misaligned.
Doing so may damage the screws.
4.
While using one hand to raise the module, connect the
included cable. Connect the "L" shaped plug of the cable
to the module's TO KYBD connector, and connect the
straight plug to the TO MODULE connector of the key-
board assembly.
The included cable is only for the purpose of connect-
ing the TO KYBD connector with the TO MODULE
connector. Do not connect it to any other connector.
5.
Raise the tab portion of the locking supports "B" to the
position shown in the illustration below, and fasten the
module to the keyboard assembly using the two screws
you removed in step 1 of "Removing the module."
M U SI
C W
O R KS
TA TI
O N/
SA M
PL ER
toward module
toward keyboard
Cross-section of
retaining bar "A"

Other cautions

Transportation
Before you transport the completed system (the keyboard
assembly and attached module), you must be sure to tighten
the two screws that fasten locking supports "B" to the mod-
ule.

Specifications

Keyboard
Controllers
Control connector
Dimensions (W x D x H)
Weight
* Appearance and specifications of this product are subject
to change without notice.
61 notes
Joystick
Ribbon controller
SW1/SW2
TO MODULE connector
1016 x 372 x 101 mm
40.0 x 14.6 x 3.9 inches
9.3 kg / 20.5 lbs.
7