Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Fitting:
The battery ground should be disconnected before working on electric wiring and switches!
Remove handlebar controls, clutch and brake cylinder assy, then remove the original clip-ons.
Assure that the front wheel is free from any load when dismounting top yoke!
Slide Match Clamps over the slide tube and reinstall the top yoke.
To fix top yoke, first tighten steering head nut up to 15Nm / 11lbf ft, then fix the slider tube's
clamping bolts with recommended torque.
Now tighten steering head nut up to the required torque, tightening torques refer to the vehicle
manufacturer's instruction.
Slide match clamps underneath the top yoke and align them provisonally and tighten them slightly.
Now install the tubes with M6x22 and tighten these bolts with 10Nm (7.31lbf ft).
To gain more clearance between clip ons and tank you have to modify the steering stop.
Use suitable glue to fix the aluminium shims (t=2mm) on the steering stop.
Now you should check the clearance to the tank, therefore you have to mount all controls
provisonally on the
Tighten the bolts of the Speed Match clamps M6x25 with 10Nm.
Now drill the bores for the controls and fix them finally. The left grip should be installed with glue.
Instruction for rerouting cables hoses and wiring harnesses:
Throttle cable : Route out of the original cable guide. Check easy movement during full
Brake line : remaining as original
Clutch line: Turn fitting at main cylinder
Wiring harness : remaining as original
Make sure that no cable, hose or harness is bended and stays tension-free over the whole steering
angle.
Connect the battery to the ground of your vehicle.
The Speed-Match kit is now completely mounted. Always check local laws and your
manufacturer's warranty conditions for using aftermarket parts on your bike!
Ride safe and have fun!
———————————————————
Rev. 00 16/02/2016
clip-on.
steering left & right.
inboard.
Zubehör von
—
Das Original
Seite 4 von 6
——
Werbung
