IKEA DJUPFRYSA Handbuch Seite 19

ENGLISH
Problem
There is too much frost and
ice.
There is too much frost and
ice.
Water flows on the floor.
Water flows on the floor.
Temperature cannot be set.
The temperature in the appli‐
ance is too low/too high.
The temperature in the appli‐
ance is too low/too high.
The temperature in the appli‐
ance is too low/too high.
The temperature in the appli‐
ance is too low/too high.
The temperature in the appli‐
ance is too low/too high.
The temperature in the appli‐
ance is too low/too high.
The temperature in the appli‐
ance is too low/too high.
The temperature in the appli‐
ance is too low/too high.
Power indicator light flashes.
Possible cause
Appliance is fully loaded and
is set to the lowest tempera‐
ture.
Temperature set in the appli‐
ance is too low and the ambi‐
ent temperature is too high.
Door was left open for a long
time.
The gasket is deformed or
damaged.
The "Fast Freezing function"
is switched on.
The temperature is not set
correctly.
The door is not closed cor‐
rectly.
The food products' tempera‐
ture is too high.
Many food products are stor‐
ed at the same time.
The thickness of the frost is
greater than 4-5 mm.
The door has been opened
often.
The Fast Freezing function is
switched on.
There is no cold air circula‐
tion in the appliance.
An error has occurred in
measuring the temperature.
Solution
Set a higher temperature. Re‐
fer to "Control Panel" chap‐
ter.
Set a higher temperature. Re‐
fer to "Control Panel" chapter
and "Location" section.
Open the door only when
necessary.
Contact the Authorised Serv‐
ice Centre.
Switch off "Fast Freezing
function" manually, or wait
until the function deactivates
automatically to set the tem‐
perature. Refer to "Fast
Freezing function" section.
Set a higher/lower tempera‐
ture.
Refer to "Closing the door"
section.
Let the food products tem‐
perature decrease to room
temperature before storage.
Store less food products at
the same time.
Defrost the appliance.
Open the door only if neces‐
sary.
Refer to "Fast Freezing func‐
tion" section.
Make sure that there is cold
air circulation in the appli‐
ance. Refer to "Hints and
Tips" chapter.
Contact a qualified electrician
or the nearest Authorized
Service Centre.
19