CLEANING AND MAINTENANCE
s
The appliance should be cleaned after every use.
●
Before cleaning, switch the appliance off with the ON/OFF toggle switch (posi
●
tion 0), wait for the appliance to come to a stop and pull the plug.
Disassemble the appliance as described in the chapter "Disassembling the
●
Multi grater" (see page 63).
Caution: The grating blades in the cutting drums are very sharp!
●
GB
All removable parts can be cleaned in water, the motor unit however must never
●
be submerged in water or any other liquid.
You can clean the removable parts in warm (not above 50 °C) dish water with
●
a sponge resp. clean the cutting drums with a dishwashing brush. After that,
dry all parts carefully.
Clean the motor unit with a slightly moist towel and some mild detergent.
●
Make sure that all parts are completely dry before reassembling the appliance.
●
In general, do not use any aggressive or scouring detergents or metal sponges,
●
as these might damage the surface.
STORAGE
s
Check, if the appliance is disconnected from the power and clean and dry.
●
Best store the appliance fully assembled and in an upright position in a dry, dark
●
space, best in the original packaging. Do not place anything on the appliance.
The 4 cutting drums that are not installed into the appliance can be safely and
●
hygienically stored in the two storage containers – two cutting drums fit into
each of the containers.
Always keep the appliance and the power cord out of the reach of children.
●
64