Technical Data; Maintenance And Cleaning - VOLTCRAFT SNPS-90 Bedienungsanleitung

Install the plug:
1. Disconnect the power supply from the mains.
2. Push the selected plug onto the male socket on the charging cable. Observe the notch, the
plug only connects one way.
b) Charging
CAUTION
Risk of fire!
Lay out the AC cord and the charging cord (DC cord) completely before charging to
facilitate heat dissipation.
1. (If connected) Disconnect the power supply from the mains.
2. Switch off the device you intend to charge.
3. Connect the plug with the charging port of the device.
4. Connect the power supply to the mains to start charging. Switch on your device, if needed.
5. When charging is completed, disconnect the power supply from the mains.

Maintenance and cleaning

• Disconnect the product from the mains and any connected device before cleaning.
• Besides occasional cleaning, the product is maintenance-free.
• Never use aggressive or abrasive cleaning agents, rubbing alcohol or other chemical
solvents, as those can damage the housing or even affect the operation of the product.
• To clean the product, a dry, soft and clean cloth is sufficient. You can easily remove dust
using a long-haired, soft and clean brush.
Disposal
Electronic devices are recyclable waste and must not be disposed of in the
household waste. At the end of its service life, dispose of the product in accordance
with applicable regulatory guidelines.
You thus fulfill your statutory obligations and contribute to the protection of the
environment.

Technical data

The efficiency data is in compliance with the ecodesign requirements set out in Annex II of
the EC regulation 2019/1782.
Input voltage ............................................... 100 – 240 V/AC
Input AC frequency ..................................... 50 – 60 Hz
Input current ............................................... max. 1.2 A
Output voltage ............................................ 19.0 V/DC
Output current ............................................. 4.73 A
Output power .............................................. 89.9 W
Average active efficiency ............................ 89.67 %
Efficiency at low load (10 %) ...................... 81.95 %
No-load power consumption ....................... 0.16 W
Cord length ................................................. AC cord: 1.2 m
Protection class .......................................... II
Operating conditions ................................... 0 to +35 °C, 10 – 95 % RH (non-condensing)
Storage conditions ...................................... -10 to +55 °C, 5 – 95 % RH (non-condensing)
Dimensions (W x H x D) ............................. approx. 138.5 x 26 x 66 mm
Weight ........................................................ approx. 389 g (without cable and plugs)
Model identifier:
Commercial registration number:
Manufacturer:
This is a publication by Conrad Electronic SE, Klaus-Conrad-Str. 1, D-92240 Hirschau (www.conrad.com). All rights
including translation reserved. Reproduction by any method, e.g. photocopy, microfilming, or the capture in electronic data
processing systems require the prior written approval by the editor. Reprinting, also in part, is prohibited. This publication
represent the technical status at the time of printing.
Copyright 2020 by Conrad Electronic SE.
DC cord: 1.5 m
SNPS-90
HRB 3896
Conrad Electronic SE, Klaus-Conrad-Str. 1,
D-92240 Hirschau
*2266529_v1_0820_02_jh_m_en