Starting Up The Appliance - Silvercrest SKKM 200 A1 Bedienungsanleitung

Starting up the appliance

NOTE
► During initial start-up, you may notice a small
amount of smoke and a slight odour coming
from the appliance. This is due to production
residue. This is normal and is completely
harmless. Ensure that sufficient ventilation is
provided by opening a window, for example.
1) Clean the appliance before initial use as
described in the section "Cleaning".
2) Place the appliance on a level surface.
3) Unwind the cable from around the cable retainer
8 and guide it through the recess at the edge of
the housing.
4) Place the silicone ring 3 on the upper part of
the grinding mechanism 4 in such a way that
the silicone ring 3 is lying flat on the upper
part of the grinding mechanism 4 and is flush
with it.
5) Insert the upper part of the grinding
mechanism 4 into the lower part 5. The dot ●
on the upper part of the grinding mechanism 4
must be aligned with the line on the housing,
so that the two catches at the side slide into the
corresponding recesses.
6) Place the coffee bean container 2 into the
housing so that the ▼ arrow on the coffee bean
container 2 is pointing to the
the appliance housing. Turn the coffee bean
container 2 a little way clockwise to lock it
into position.
SKKM 200 A1
NOTE
► The appliance can not be operated unless the
coffee bean container 2 has been correctly
inserted.
7) Insert the power plug into a mains wall socket.
8) When you use the appliance for the first time,
proceed as follows to remove any production
residue:
–
Open the rubber closure in the lid e of the
coffee powder container r and push this into
the appliance beneath the output opening 7 so
that it is located securely in the round recess.
–
Add 3 tablespoons of coffee beans into the
coffee bean container 2 and replace the
lid 1.
–
Turn the coffee bean container 2 clockwise
until the ▼ arrow on the coffee bean container
2 is above the 15 on the scale for adjusting
the grind setting 6.
–
Turn the dial 9 to position 2 and press the
start/stop button
process.
The grinding process stops automatically as
soon as the set quantity of coffee powder is
reached.
NOTE
► Before removing the coffee powder container
r, tap gently on the housing in front of the
output opening 7 so that any loose coffee
powder residue falls into the coffee powder
container r.
–
Remove the coffee powder container r and
dispose of the ground coffee.
9) Add a maximum of approx. 250 g of coffee
beans into the coffee bean container 2, and
the lid 1 should still close. If necessary, carefully
symbol on
shake the appliance so that the coffee beans
are evenly distributed in the coffee bean
container 2.
The appliance is now ready for use.
0 to start the grinding
GB │ IE │
17 ■