Assembling The Appliance; Operating The Appliance - Silvercrest SKKM 200 A1 Bedienungsanleitung

Assembling the appliance

NOTE
► For quality assurance reasons, every coffee
grinder is tested at the factory using coffee
beans. Small amounts of coffee powder might
therefore remain in the grinding mechanism.
This does not mean your originally packaged
appliance is not brand new.
1) Clean the appliance before initial use as
described in the section "Cleaning".
2) Place the appliance on a level surface.
3) Unwind the cable from around the cable retainer
8 and guide it through the recess at the edge of
the housing.
4) Place the silicone ring 3 on the upper part of
the grinding mechanism 4 in such a way that
the silicone ring 3 is lying flat on the upper
part of the grinding mechanism 4 and is flush
with it.
5) Insert the upper part of the grinding
mechanism 4 into the lower part 5. The dot ●
on the upper part of the grinding mechanism 4
must be aligned with the line on the housing,
so that the two catches at the side slide into the
corresponding recesses.
6) Place the coffee bean container 2 into the
housing so that the ▼ arrow on the coffee bean
container 2 is pointing to the
the appliance housing. Turn the coffee bean
container 2 a little way clockwise to lock it
into position.
SKKM 200 A1
NOTE
► The appliance can not be operated unless the
coffee bean container 2 has been correctly
inserted.

Operating the appliance

NOTE
► When starting the appliance for the first time,
you may notice a small amount of smoke and
a slight odour coming from the appliance. This
is due to production residue. This is normal and
is completely harmless. Ensure sufficient
ventilation; for example, by opening a
window.
♦ If you are using the appliance for the first time,
proceed as follows to remove any production
residue:
1) Set up the appliance, as described in the
previous section.
2) Insert the power plug into a mains wall socket.
3) Open the silicone plug r in the lid e of the
coffee powder container t and push it into the
appliance under the output opening 7 so that
it sits stably in the round recess.
4) Add 3 tablespoons of coffee beans into the
coffee bean container 2 and replace the
lid 1.
5) Turn the coffee bean container 2 clockwise until
the ▼ arrow on the coffee bean container 2 is
above the 15 on the scale for adjusting the
grind setting 6.
6) Turn the dial 9 to position 2 and press the
start/stop button
process. The grinding process stops
automatically after about 12 seconds.
symbol on
7) If some of the coffee beans have still not been
ground at the end of the grinding process, start
it again by pressing the start/stop button
0 to start the grinding
GB │ IE │
5
0.
■