Getting Started And General Operation; Adjusting The Sound - auna 10026465 Handbuch

Connecting mains power
• Connect the attached mains plug to a mains power supply outlet.
• Switch the power outlet ON.
Standby mode
• Press the STANDBY button (U2 Unit & R3 Remote). to wake the unit from STANDBY mode.
• To enter STANDBY mode press either STANDBY buttons (U2 Unit & R3 Remote).
• NOTE: As part of the power saving mode the unit will enter STANDBY mode automatically after 10
minutes (approx) of no audio output.
Playing audio from a connected TV or other devices
• After connecting a TV or other device to the Sound bar, follow
the below steps.
• Ensure the Sound bar is powered ON. If not press the STANDBY
button (U2) or remote (R3).
• Press the SOURCE button (U3,R2) repeatedly to choose the cor-
rect source to play. The source icon will appear on the display.
• Adjust the output volume using the VOLUME +/- buttons (U6
Unit or R5 Remote).
Digital Audio Connections
Please note when connecting the soundbar using DIGITAL cables (COAXIAL or OPTICAL), the AUDIO
SOURCE MUST be set to output PCM digital audio.
Volume controls
• To increase the volume level press the VOLUME + button (U6 Unit or R5 Remote) repeatedly or
press and hold for fast adjustment.
• To decrease the volume level press the VOLUME - button (U6 Unit or R5 Remote) repeatedly or
press and hold for fast adjustment.
Sound mode presets
• During playback pressing the SOUND MODE button on the re-
mote control (R11) repeatedly cycles through the available
sound modes. Choose between :- STANDARD, MOVIE, MUSIC
or NEWS.
• As you select a sound mode, the corresponding name appears
on the display to indicate that sound mode is active.
• NOTE: The STANDARD sound mode when selected does not
show an icon on the display.
Getting Started
General Operation

Adjusting the Sound

18
18