Wall Mounting And Prepairing The Remote - auna 10026465 Handbuch

1. Align the Sound Bar in the chosen location.
Use a pencil to mark the drilling positions
750mm apart.
NOTE: The Sound Bar should be located at
least 7.5cm below the bottom of the TV.
2. Drill holes as marked in step 1.
Prepairing the remote
Push open the battery compartment on the bottom of the remote control using
a fingernail. Insert a CR2025 battery into the space taking care to match the +
and - polarity symbols correctly. Replace the battery compartment.
Wall Mounting Advice
3. Insert 2 screws (not supplied) into the holes
and tighten. Take care to leave 5mm bet-
ween the screw heads and the wall.
NOTE: You will need to ensure the screws
are long enough to sufficiently grip the wall
while allowing 5mm between screw head and
wall.
4. Hook the Sound bar into the screws. For se-
cure mounting ensure the crew heads slide
firmly into the narrow part of the brackets.
16
16